9.4.15 |
IP trunks for SIP providers and OpenScape Office |
| The following are configured via IP Trunks : |
| • | IP trunks for SIP providers of the inserted HG 1500 boards |
| • | IP Trunks for OpenScape Office |
| See also Section 9.4.14 "IP trunks for HG 1500". |
9.4.15.1 |
Area: Selection |
Gatekeeper HG 1500 |
| Under HG 1500 Gatekeeper, select the HG 1500 board plugged into the communication system that is configured as a gatekeeper (see also Settings | Set up station | Gatekeeper). |
Enable gateway resources flag |
| Activating this flag enables gateway resources. |
9.4.15.2 |
Trunks table |
| The table shows all the lines that have been set up for the HG 1500 board. |
Number, Add |
| The type and number of new trunks that should be configured are specified here. In total, up to 8, 16 or 64 trunks can be configured depending on the board. A higher number of trunks will be ignored. In the HiPath systems, trunks with particular routes are assigned to the SIP providers. These routes are: |
| |
|
| The number and the "IP Trunking" type of the IP trunks are specified here for OpenScape Office. |
Trunk column |
| This is the physical CO trunk that is connected to the communication system. You select the trunk (line) by clicking on the appropriate line number. |
Code column |
| This is the number that tells the communication system to seize a specific trunk. It is used to test the trunk or to program a line key. |
Route column |
| This is the route (number or name) to which the specified line is assigned. These are the same names and numbers that appear in the Routes field under Routes and Routing parameters. You use this field to assign a line to a particular route. |
Selected line, Delete |
| All selected lines are deleted by pressing Delete. |
Configured line |
| This field shows the number of IP trunks/trunks configured for the HG 1500 board. |
| HiPath 3000/5000 V9, Manager E, Administrator Documentation, Issue 7 | up  |
|
 |
||
| Disclaimer & Copyright | ID: P31003H3590M1000176A9 | 2012-06-25 |
