8.2 |
Station parameters |
| On selecting a station in the "Station selection" dialog, the parameters for the selected station are displayed on the right. You can then edit the parameters for the station via the tabs or view the status of the station. For parameters that cannot be edited here, you will find a link (arrow symbol) next to each such parameter that enables you to switch directly to the appropriate dialog in the system view where you can then set the parameters as required. |
Name |
| The name assigned to the station is entered here. The name can be a person's name, the name of a department or any other suitable entry. The name can contain a maximum of 16 characters. |
| Note that no validity check is performed for the entered characters, so it is your responsibility to ensure that only valid characters are used. |
| The following ISO 8859-1 characters can be entered: |
| - | Character 32 through 127 (the usual West-European characters, digits, letters) |
| - | German Umlauts (Ä, Ö, Ü, ä, ö, ü) |
| - | the characters Å, Æ, Ñ, Ø, Õ, õ. |
| Characters that are not permitted will be replaced with a space in the display. |
| When setting language conversion "Greek" or "Cyrillic", the letters of the Greek or Cyrillic alphabet can be entered in capital letters. |
Station Number |
| The internal call number of each station is shown here (see also Subscriber). To change the call number, click on the arrow symbol after the number. |
CLIP/LIN |
| The valid DID (direct inward dialing) number for CLIP or LIN is shown here (see also Subscriber). To change the call number, click on the arrow symbol after the CLIP/LIN. |
Direct inward dialing (DID) |
| The DID number assigned to the corresponding extension is displayed here (see also Subscriber) To change the DID number, click on the arrow symbol after the DID. |
Type |
| Can only be changed by physically reconfiguring the communication system. |
| The type of telephone connected to the station port is automatically specified by the communication system. If a telephone is not connected, No Port is displayed in the column. If an analog telephone is connected, the column entry is "No Fe". |
| - | No Port, i.e. no telephone connected |
| - | No Fe, i.e. analog telephone connected |
| - | System telephone connected |
| - | S0 station |
Access |
| Can only be changed by physically reconfiguring the communication system. |
| The name, number, slot of the station system board and the type of Workpoint Client (SYS=System, S0) are displayed here. This column also indicates whether the port is a master or a slave. |
Mobile code |
| The status of the mobile phone and the PIN code to log on the mobile telephone are displayed here (see also Cordless | SLC, Area: Portable Parts). To change the PIN code, click on the arrow symbol after the mobile code. |
| |
| HiPath 3000/5000 V9, Manager E, Administrator Documentation, Issue 10 | up |
|
|
||
| Disclaimer & Copyright | ID: P31003H3590M1000176A9 | 2014-03-03 |