9.5.1  

Flags and COS 
 


Settings | Least Cost Routing Flags and COS
 
The automatic LCR is activated via Flags and COS and the LCR authorization for each individual station determined.

9.5.1.1  

Class of service table 

Call No. (call number) column  
All call numbers in the communication system are listed in this column.

Name column  
The station names that are allocated to the call numbers are listed here.

Class of service column  
An LCR class-of-service (1-15) can be assigned to each station which is evaluated by means of the route table when a route is being seized. The assigned level must be equal to or greater than the level associated with the Route group selected to gain access to the service.

9.5.1.2  

LCR authorization codes table 
The authorization codes or P.I.N (Personal Identification Number) allocated to the individual network providers are transmitted together with the call number.

Index column  
Consecutive digits are entered here in accordance with the respective network provider. In the dial rule, the entries M1-M16 refer to index 1-16.

P.I.N. column  
Sixteen authorization codes of not more than 16 characters (ASCII characters) can be entered for the various network providers.

9.5.1.3  

Area: LCR - flags, Activate LCR 
Automatic least cost routing can be activated with Activate LCR.

9.5.1.4  

Digit Transmission area (HiPath 3000/5000 V7 R4) 
The type of digit transmission is established here throughout the system.

Digit-by-digit  
The digits are transmitted in sync with dialing.

En-bloc sending  
During en-block sending digit transmission, the digits are cached by the communication system. Dialing only takes place when a timer has elapsed after the last digit has been dialed, when the end-of-dial code # has been entered or if an exact match in the dial rule is found. In the case of PRI in the USA block dialing to the central office is mandatory.

See also:  
   -   Section 9.5.2 "Dial plan"
   -   Section 9.6 "Settings | Incoming calls"