E  
Notes for Editing the File snmpd.cnf 
 

E.1  
Introduction 
 
The SNMP parameters required for HiPath 5000 are defined when installing the FM Reporting Client (SNMP Master Agent). This refers to the trap destinations and the names of the HiPath Fault Management desktop communities.
The FM Reporting Client does not have its own user interface. The SNMP parameters defined during installation may only be changed by uninstalling and then reinstalling the FM Reporting Client.
Users with sufficient knowledge of SNMP can change trap destinations and community names by editing the file snmpd.cnf. The file can be found in the installation directory of the FM Reporting Client.
The following notes on editing the file snmpd.cnf are intended exclusively for users with sufficient knowledge of SNMP.  
Note: The syntax of entries in the FM Reporting Client configuration file (SNMP master agent) is appended to the element description in the SNMP-TARGET-MIB (RFC 3413 - Chapter 4, cf. http://www.zvon.org ).  

HiPath 3000/5000 V8, Service Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3580S100017620   2011-01-24