Table 1-1

Chapters in this Service Manual

Chapter	Description
Chapter 1 "Introduction and Important Notes"	Chapter 1 "Introduction and Important Notes" contains the basic information necessary for working with the product and with this service manual. The safety information and warnings as well as the standards and guidelines regarding installation, including lightning protection, must be observed.
Chapter 2 "System Data"	Chapter 2 "System Data" provides information on the current HiPath 3000/5000 version and associated systems (characteristics, construction, system environment, capacity limits, technical data).
Chapter 3 "Boards for HiPath 3000"	Chapter 3 "Boards for HiPath 3000" describes all of the boards used for HiPath 3000. The hardware information (such as connection cables and NT connections) is presented for each board.
Chapter 4 "Installing HiPath 3000"	The actions necessary for the standard installation (part of a standard system) of the different Chapter 4 "Installing HiPath 3000" systems are described in HiPath 3000.
Chapter 5 "Starting Up HiPath 3000"	The procedures for the startup of the individual HiPath 3000/5000 components are described in Chapter 5 "Starting Up HiPath 3000", Chapter 6 "HiPath 5000 Startup and Administration" and Chapter 7 "Starting HiPath 3000 as a Gateway".
Chapter 6 "HiPath 5000 Startup and Administration"
Chapter 7 "Starting HiPath 3000 as a Gateway"
Chapter 8 "Licensing"	Chapter 8 "Licensing" contains information about HiPath License Management.
Chapter 9 "Expanding and Upgrading HiPath 3000"	Information on supplementary equipment and expansions and on the procedure for upgrading HiPath 3000 systems are part of Chapter 9 "Expanding and Upgrading HiPath 3000".
Chapter 10 "Workpoint Clients"	Chapter 10 "Workpoint Clients" contains the description of the workpoint clients supported.
Chapter 11 "HiPath Cordless Office"	Basic information about the operation of the HiPath Cordless Office are part of Chapter 11 "HiPath Cordless Office".
Chapter 12 "Service"	Chapter 12 "Service" describes service and maintenance tasks and provides information on error detection and troubleshooting.
Chapter 13 "IP Fundamentals"	Introductory information on the subject of IP can be found in Chapter 13 "IP Fundamentals".
Appendix A "System Programming Codes (Expert Mode Codes)"	The following appendices contain lists with programming codes, IP protocols, port numbers: Appendix A "System Programming Codes (Expert Mode Codes)", Appendix B "Codes for Activating/Deactivating Features" and Appendix C "IP Protocols and Port Numbers Used with HiPath 3000/5000 V7 and Higher".
Appendix B "Codes for Activating/Deactivating Features"
Appendix C "IP Protocols and Port Numbers Used with HiPath 3000/5000 V7 and Higher"
Appendix D "Identifying System Power Requirements"	Appendix D "Identifying System Power Requirements" provides information about the resource requirements of the boards and components of the HiPath 3000 systems.
Appendix E "Notes for Editing the File snmpd.cnf"	Appendix E "Notes for Editing the File snmpd.cnf" is aimed at users with sufficient SNMP knowledge to modify trap destinations and community names in HiPath Fault Management Desktop.
Appendix F "Components of the Linux Server of OpenScape office HX"	Appendix F "Components of the Linux Server of OpenScape office HX" lists the required components for operation of the Linux server required for the OpenScape Office HX application.
Appendix G "Country Versions"	Appendix G "Country Versions" lists the countries with their own country code and the countries with "IM" country code that can be set in the Manager E to configure HiPath 3000/5000.