10.1.8 |
Line states |
| Out of Service can be used to display all station and line ports available in the communication system. Unavailable lines or lines that are not ready for operation are preceded with an *(asterisk), i.e., they are unavailable. |
10.1.8.1 |
Table: Trunks |
| All trunks available in the communication system are entered in the Trunks table. The line number is the number assigned to the trunk by the system software. The next number is the slot/port location within the system. The final number is the dial number for the trunk. |
| When you select a particular line, the line parameters for that trunk are displayed in the fields on the right. The values cannot be changed here. You can, however, change individual parameters via Settings | Lines/networking. |
Code |
| The code number is the number you dial to get access to this specific trunk to place a call. This number can be changed via Settings | Lines/networking. |
Trunk |
| This is the trunk number assigned by the communication system. |
Route |
| The route number shows which of the eight (or sixteen) routes this trunk has been assigned to. |
Type |
| This is the trunk type, such as CO or CO DTMF. |
Trunk Type |
| This is the trunk dialing type, such as Analog or S0. If the trunk is inactive, No Port is displayed in this field. |
Trunk Status |
| This indicates whether the trunk is currently active or inactive. |
| |
| HiPath 3000/5000 V8, Manager E, Administrator Documentation, Issue 10 | up  |
|
 |
||
| Disclaimer & Copyright | ID: P31003H3580M1000176A9 | 2011-01-24 |
