3 Features for General Traffic

3	Features for General Traffic

3.1	Features for General Incoming Traffic

3.1.1	Distinctive Ringing

Implementing features, see also Manager E Distinctive Ringing

Definition

Distinctive tones indicate different call types. This enables the user to distinguish between incoming internal and incoming external calls. In ISDN systems, acoustic information is secondary to displays on the screen because different features can have the same ring signaling.

In V6.0 and later, call signaling that varies from caller to caller is also possible.

Consequently, in addition to external call signaling, it is also possible to configure internal call signaling for each station. Every internal call made by this station (calling station) is signaled by the ring type on station B (called station). The call frequency on the destination conforms to the call frequency of the caller. This is achieved by assigning a certain call frequency to a station via the Manager E. As with the existing field for external calls ("Call signaling"), the new internal call frequencies are controlled by Manager E (and not by Manager C).

The different ring frequencies are applied to the called stations in the case of station type HFA (UP0/E or IP). Analog stations are always called using frequency 1.

The different internal ring frequencies only function between end points that are registered in the same system or node.

Seven additional ring frequencies will be added to the existing ring frequency. These frequencies will have different default values, whereby each station is displayed with frequency 1 by default.

CMI handsets

Gigaset 7000 and Gigaset SL1 will support CLIP in V6.0 SMR-07 or later. CLIP information will also be transmitted to the Gigaset over a DECT information element for this.

Gigaset 7000 supports the VIP ring feature that applies a special ring signal (Gigaset software 22.041). For this to work, individual ring tones must be defined for phonebook entries in the internal phonebook in Gigaset 7000 (for example, SL55). Callers are identified on the basis of the CLIP information received.

The prerequisite for VIP ring signaling in an internal station is that this station sets ring type 1 internally for call signaling.

VIP ring does not work in Gigaset if the preset call signaling type is changed from 1 to ring type 2 to 8. In other words, the assigned melody will not play, even if VIP ring is set in the internal phonebook.

Acoustic signaling

Depending on the telephone, three different types of acoustic signaling are possible:

•	for optiPoint 500 and OpenStage CorNet-IP (HFA) telephones (also applies to IP telephones on HiPath 5000):

Ring type 1 = External call CO (for example, double ring)

Ring type 2 = External call CO 2 (for example, triple ring)

Ring type 3 = External call CO 3 (for example, short/long/short)

•	for analog telephones (only for Germany):

Ring type 1 = External call CO (for example, double ring)

Ring type 2 = Recall

Ring type 3 = Door bell ring

•	for analog telephones (not for Germany):

Ring type 1 = External call CO (for example, double ring)

Ring type 2 = External call CO (for example, double ring)

Ring type 3 = External call CO (for example, double ring)

The ring cadences depend on the country.

Model-Specific Data

Subject

HiPath 3800

HiPath 3550

HiPath 3500

HiPath 3350

HiPath 3300

Feature available in

Hardware requirements

Software requirements

V5.0 or later

V1.0 or later

Dependencies/Restrictions

Subject

Dependency/Restriction

Country specifics

Ring signals are country-specific and determined by the approval authorities.

HiPath 3000/5000 V8, Feature Description, Issue 10		up

Disclaimer & Copyright	ID: P31003H3580F100017618	2011-02-07